I had to add the following to /etc/modprobe.conf to get the
cards running at 100 full:
options duplex_full=1,1
On Sun, 23 Apr 2006 12:43:25 +0200
"it clown"
Hi All,
I have 2 3com 3c980c-txm network cards. I am having trouble to get them running at 100 full duplex.
ethtool reports the cards are running at 10 half duplex
I have tried the following:
ethtool -s ethx autoneg off duplex full speed 100
After that ethtool reports the card is running at 100 full duplex.
But the card is actually still running at the speed of 10 half duplex.
I installed winxp on the machine to see if i will have the same problem but in winxp it works 100% running at 100 full duplex.
Can anyone help me out getting it to work at 100 full duplex under suse9.3?
Thanks Regards ___________________________________________________________________ For super low premiums, click here http://www.webmail.co.za/dd.pwm
http://www.webmail.co.za the South African FREE email service
-- Check the headers for your unsubscription address For additional commands send e-mail to suse-linux-e-help@suse.com Also check the archives at http://lists.suse.com Please read the FAQs: suse-linux-e-faq@suse.com
___________________________________________________________________ For super low premiums, click here http://www.webmail.co.za/dd.pwm http://www.webmail.co.za the South African FREE email service