On 4/19/06, Audrius Verseckas
On 4/18/06, Tim Harper
wrote: If its named eth1, its likely not configured properly.
Try reconfiguring it with YAST, under the network card configuration component? Delete the configuration for eth1, and create a new wireless one. Under the hardware selection dialog, if you're card isn't listed as being supported, you'll have to install ndiswrapper, and then install the windows driver (which is what I had to do).
I do not think so... System detects card correctly... only can not get it up... And I think because of not correct firmware...
I found on http://jbnote.free.fr/prism54usb/ site that if I have a PCI softmac card (and it seems that my SMC2802W V2 is) I have to put special firmware in
/usr/lib/hotplug/firmware/
But I cannot find such dir in Suse 10.1... Maybe someone could point me where I have to put it?
dmesg shows me: eth1: resetting device... eth1: uploading firmware... prism54: request_firmware() failed for 'isl3890' eth1: could not upload firmware ('isl3890') eth1: islpci_reset: failure Why Suse is trying to load 'isl3890'? I think that my card is 'isl3886'. Is there a wireless guru here which could tel me how can I identify my card? It looks like this: http://heureka.inf.elte.hu/home/vlsoft/smc/SMC2802W_front.jpg http://heureka.inf.elte.hu/home/vlsoft/smc/SMC2802W_back_nomac.jpg Audrius