It's communicating via the VP12 (imm) interface. Joe G wrote:
Hi,
I used "modprobe ppa" and "dmesg" and fouind the following info for my Iomega ZIP100 parellel port drive:
Vendor: IOMEGA Model: ZIP 100 Rev: P.05 Type: Direct-Access ANSI SCSI revision: 02 SCSI device sda: 196608 512-byte hdwr sectors (101 MB) sda: Write Protect is off sda: Mode Sense: 25 00 00 08 sda: cache data unavailable sda: assuming drive cache: write through SCSI device sda: 196608 512-byte hdwr sectors (101 MB) sda: Write Protect is off sda: Mode Sense: 25 00 00 08 sda: cache data unavailable sda: assuming drive cache: write through sda: sda4 Attached scsi removable disk sda at scsi0, channel 0, id 6, lun 0 Attached scsi generic sg0 at scsi0, channel 0, id 6, lun 0, type 0
Does anyone out there know the path I should set in Konqueror>Storage Media>Edit>Selection>Create New>Link to Device>Zip Device?
My system did find it somehow after this as I was writing this...The device started blinking wildly for a moment, clicked, and then stopped. Some communicatiion took place.
Thanks, -Joe G moment and the stopped.