Hello everybody. I've installed SuSE 9.2 Pro (x86) (2.6.8-24.16-bigsmp) to an HP-Proliant DL360 with an array controller: lspci -v says: 0000:0b:04.0 RAID bus controller: Compaq Computer Corporation Smart Array 64xx (rev 01) Subsystem: Compaq Computer Corporation Smart Array 6400 hwscan detects this: cB5L.gwvXxx1Amj4: (cfg=yes, avail=yes, need=no, active=unknown) storage Compaq Smart Array 6400 Connected to it is an external tape unit: HP StorageWorks Ultrium 460 While booting the server the card and the tape unit gets recognized: Slot 2 HP Smart Array 6400 Controller (192 MB, v2.34) 1 Logical Drives Tape or CDROM Drive(s) Detected SCSI Port 2: SCSI ID 3 But when loading the kernel, there does not appear messages seeing the tape unit, the st module gets loaded but without any dependent device. If i issue: mt -f /dev/sr0 status an error occurs. What can i do? , rh7-9 detect this device witouth adding anything. Is there something i forgot to do in order to make SuSE recognize the tape? Any suggestion is wellcomed. Regards Oxiel ___________________________________ Yahoo! Mail: gratis 1GB per i messaggi e allegati da 10MB http://mail.yahoo.it