Hi,
No If I load the bond and configure manually, I don't see this message.
If my bond is not loaded and I call /etc/init.d/network start, I face
this problem.
Thanks,
Anil
-----Original Message-----
From: Ben Higginbottom [mailto:b.higginbottom@trinityhigh.com]
Sent: Wednesday, November 03, 2004 6:23 PM
To: Anil V Gangur
Cc: suse-linux-e@suse.com
Subject: RE: [SLE] Bonding in SuSE SLES9
On 03/11/04 12:40 PM, Anil V Gangur
Hi,
Bond can be configured by following the procedure mentioned in the location.
But I am seeing each time when I start the network, during enslaving
it
results in "Illegal operation: bond is not up message."
I can see bond configuring properly. Why are these messages?
Never seen that before, does strace provide anything useful when you start network manually? Regards, Ben Confidentiality Notice The information contained in this electronic message and any attachments to this message are intended for the exclusive use of the addressee(s) and may contain confidential or privileged information. If you are not the intended recipient, please notify the sender at Wipro or Mailadmin@wipro.com immediately and destroy all copies of this message and any attachments.