3 Nov
2004
3 Nov
'04
17:42
On Wed, 2004-11-03 at 04:40, Anil V Gangur wrote:
Hi,
Bond can be configured by following the procedure mentioned in the location.
But I am seeing each time when I start the network, during enslaving it results in "Illegal operation: bond is not up message."
I can see bond configuring properly. Why are these messages?
Thanks, Anil
I had this occur originally as well because I was loading the bonding driver manually. Did you start this out fresh or did you try to correct your previous attempts? Brad Dameron SeaTab Software www.seatab.com