OS: SuSE 9.0 SCSI HBA: ADaptec 39160 SCSI HD: Single 36GB attached to Channel A with SCSI ID 0 Tape Drive: Tandberg SLR4 with SCSI ID 2 (not yet installed) This system was installed with the sole SCSI HD attached to the 39160 Channel A internal 68-pin connector but now I want to move the tape drive from another system to this one. Sccording to the 39160 Installation Guide, which has the following caution: Do not connect SCSI devices to more than two of the three SCSI Channel A connectors at the same time which would seem to imply I could simply connect a 50-pin cable to the 50-pin internal Channel A connector for the tape drive without violating the caution. Is this correct? Will adding the tape drive to an installed system mess anything up? If so, how should I go about this? Thank you, Lucky Leavell