-----Original Message-----
From: Bruce Marshall
Hi,
I just added an Adaptec 29160 and a used Benchmark VS80/DLT1 (aka Quantum VS80 & Dell PowerVault 110T) to my SuSE SLES8 machine. On boot I get
On Sunday 29 February 2004 06:39 pm, Hans Forbrich wrote: the
message at the bottom (as well as other messages - don't want to clutter this list).
Any comments, advice, etc. appreciated.
TIA/Hans
from DMESG ....
scsi0 : Adaptec AIC7XXX EISA/VLB/PCI SCSI HBA DRIVER, Rev 6.2.29
aic7892: Ultra160 Wide Channel A, SCSI Id=7, 32/253 SCBs blk: queue f7fbde14, I/O limit 4095Mb (mask 0xffffffff) scsi0:A:3:0: DV failed to configure device. Please file a bug report against this driver. (scsi0:A:3): 20.000MB/s transfers (10.000MHz, offset 15, 16bit) Vendor: BNCHMARK Model: DLT1 Rev: 391B Type: Sequential-Access ANSI SCSI revision: 02 blk: queue f7fbda14, I/O limit 4095Mb (mask 0xffffffff)
Have you checked all of the settings on the controller? And were there any error messages during POST at boot up?
This setup should not produce any errors and correctly shows that the tape drive can do 20MB/s. Add a couple of 169MB/s drives and you will have a very fast files system as well. Ken