Using the PCI FastTrak TX2 (FastTrak100 TX2/LP). BIOS version 2.00.0.24 "lspci -v" info under SuSE 8.1 ----------------------------------- 00:13.0 RAID bus controller: Promise Technology, Inc. 20268R (rev 02) (prog-if 85) Subsystem: Promise Technology, Inc.: Unknown device 4d68 Flags: bus master, 66Mhz, slow devsel, latency 64, IRQ 12 I/O ports at d800 [size=8] I/O ports at dc00 [size=4] I/O ports at e000 [size=8] I/O ports at e400 [size=4] I/O ports at e800 [size=16] Memory at e8040000 (32-bit, non-prefetchable) [size=64K] Expansion ROM at e6000000 [disabled] [size=64K] Capabilities: [60] Power Management version 1 ----------------------------------- PCI info SuSE 8.2 install ----------------------------------- Bus 0, device 19, function 0: RAID bus controller: Promise Technology, Inc. 20268R (rev 02) IRQ 12. Master Capable. Latency=64. Min Gnt=4.Max Lat=18. I/O at 0Xd800 [0Xd807]. I/O at 0Xdc00 [0Xdc03]. I/O at 0Xe000 [0X007]. I/O at 0Xe400 [0Xe403]. I/O at 0Xe800 [0Xe80f]. Non-prefetchable 32-bit memory at e8040000 [e804ffff]. ----------------------------------- "/var/log/boot.msg" info under SuSE 8.1 ----------------------------------- <4>PDC20270: IDE controller on PCI bus 00 dev 98 <6>PCI: Found IRQ 12 for device 00:13.0 <6>PCI: Sharing IRQ 12 with 00:14.0 <4>PDC20270: chipset revision 2 <4>PDC20270: not 100%% native mode: will probe irqs later <4>PDC20270: ROM enabled at 0xe6000000 <4>PDC20270: (U)DMA Burst Bit ENABLED Primary MASTER Mode Secondary MASTER Mode. <4> ide2: BM-DMA at 0xe800-0xe807, BIOS settings: hde:pio, hdf:pio <4> ide3: BM-DMA at 0xe808-0xe80f, BIOS settings: hdg:pio, hdh:pio ----------------------------------- Kernel messages info under SuSE 8.2 install ----------------------------------- PDC20270: IDE controller at PCI slot 00:13.0 PCI: Found IRQ 12 for device 00:13.0 PCI: Sharing IRQ 12 with 00:14.0 PDC20270: chipset revision 2 PDC20270: not 100% native mode: will probe irqs later PDC20270: ROM enabled at 0xe6000000 PDC20270: neither IDE port enabled (BIOS) ----------------------------------- Under SuSE 8.1 it's detected and sees the 4 harddisks (2 mirror array's) and the raid partitions. Under SuSE 8.2 it's detected but it say's that the ide ports are disabled in the bios. Is this a well known problem????? Has anybody else these problems????? -- Thanks in advance, Stefan -------------------------------------------------------------- Linux a world without borders, fences, windows and gates..... Titanic98 "Which computer do you want to sink today????"