I would like to know the correct way to setup multiple interfaces to the Internet and internal LAN (for SuSE 8.0 prof) I know what to do, I just do not want that SuSE makes than changes after I finished ;-) Interface connections; eth0 goes to ISP-1 IP address 11.22.33.16 netmask 255.255.255.248 eth1 goes to ISP-2 single IP address 44.55.66.77 eth2 goes to ISP-3 single IP address 88.99.100.111 eth3 goes to the Internal LAN 192.168.150.0/24, 192.168.151.0/24 and 10.0.0.0/8 eth0 has also a tunnel for IPv6 eth1 will get as well another tunnel for IPv6 eth3 will have the IPv6-prefix from each ISP, but the remaining address same for both IPv6 address spaces I use Monmotha's firewall script with multiple Internet interfaces (new one, released today) I want to install zebra for an optimized routing to these 3 ISPs (No experience yet, but would like to get some hints) (with private ASN 65001) At the moment I have setup: eth0 to the Internet only and use a second router with NAT for the ISP-2, and with DHCP I have setup that every LAN user uses ISP-2, but still can use the server local via 192.168.150.1. I have setup the DNS with internal and external view and apache with both (Internal and external IP address) I tried to use Yast Network card configuration and have set the eth1 to the IP address and added a routing for the ISP at eth1, that works from the server, but does not work from the LAN. I have setup the routing gateway in /etc/dhcpd.conf to the IP address or to 192.168.150.250 (alias IP to eth1). Any hints? bye Ronald -- Ronald Wiplinger (CEO of ELMIT) http://www.elmit.com +886 (0) 915 653-452 - I'm a SpamCon Foundation Member, #694, Verify it at http://www.spamcon.org