On Friday 10 May 2002 13:39, Rafael E. Herrera wrote:
-------------------------------- Yast recognises the cards:
3Com Corporation 3C905B Fast Etherlink XL 10/100 Configured as eth0 with address 192.168.0.22 Realtek Semiconductor Co., Ltd. RT8139 Configured as eth1 with address 192.168.0.1
but has added nothing to /etc/modules.conf as it usually did with 7.3. I have done a: modprobe 3c59x modprobe 8139too but still I can only get anything out or into the eth0.
I have added alias eth0 3c59x alias eth1 8139too to /etc/modules.conf and rebooted. Still nothing from eth1
What am I mising?
A proper routing table. What is the output of "route -n"?
Do you know from your ISP what is the IP number of their gateway?
Hi and many thanks. Of course I will get the information from the route -n and the IP. It's just that we've never had to do this before. We just put in 192.168.0.254 as a dummy gateway in Yast and all our previous servers have worked fine. But that was under 7.3. has this changed for 8.0? Our ISP confirms this and says that we don't need it as our ADSL router does it for us. Back tomorrow with the route -n. Meanwhile, are my alias and modprobes above correct? Thanks, Steve.