Hello ML!
all bigger file transactions fail with my scsi devices on my suse 7.1 system
(kernel 2.4.10). After a while the device stops copying. Then the scsibus
gets reseted. A few minutes later the copying starts again for a moment and
stopps then - until next reboot. At this point most scripts like halt or
shutdown. I already tried cables and checked termination.
below youll find syslog, hardwarespecs, serialno.
thx!
-Syslogd-
sirocco kernel: scsi0:0:1:0: Attempting to queue an ABORT message
sirocco kernel: scsi0:0:1:0: Device is active, asserting ATN
sirocco kernel: Recovery code sleeping
sirocco kernel: Recovery code awake
sirocco kernel: Timer Expired
sirocco kernel: aic7xxx_abort returns 8195
sirocco kernel: scsi0:0:1:0: Attempting to queue an ABORT message
sirocco kernel: scsi0:0:1:0: Cmd aborted from QINFIFO
sirocco kernel: scsi0:0:1:0: Cmd aborted from QINFIFO
sirocco kernel: aic7xxx_abort returns 8194
[..repeated 6 mal..]
sirocco kernel: scsi0:0:1:0: Cmd aborted from QINFIFO
sirocco kernel: aic7xxx_abort returns 8194
sirocco kernel: scsi0:0:1:0: Attempting to queue a TARGET RESET message
sirocco kernel: aic7xxx_dev_reset returns 8195
sirocco kernel: Recovery SCB completes
- relevante hardware: -
Adaptec AIC7XXX EISA/VLB/PCI SCSI HBA DRIVER, Rev 6.2.1