Hi again, Just to mak sure if i got it correct. Do you mean by root directory i need to log in as root and then "make " and "Make clean" in the shall? thx emin -- On Tue, 18 Dec 2001 07:53:35 John Lamb wrote:
You may need to check that you are in the right directory. Usually you compile from the root directory of the source code. Typically subdirectories don't have their own "clean" targets. JDL
emir limar wrote:
Hi everyone, I need some help to compile my ppp. The eason is i insalled Eric Young's Des library (libdes-4.01.tar) for MS Authentication problems. The Des library installed to the following path " /usr/local/lib " as it said on the kppp' .Now Eric Young's Des library is under "/usr/local/lib" The problem is i am new to linux. And i don't know how to compile kppp Can anyone write me the full command for compiling kppp.
Readme.MSCHAP80 Now the followin section need to be done.
[You "I" should now be ready to (re)compile the PPPD.????? Go to the pppd subdirectory ????and make sure the Makefile contains "-DCHAPMS" in the CFLAGS or COMPILE_FLAGS macro, and that the LIBS macro (or LDADD for BSD systems) contains "-ldes". Depending on your system and where the DES library was installed, you may also need to alter the include and library paths used by your compiler.]
1- how can i compile and where? ie: shell, ? 2-is there any path that i need to follow? If i am not wrong my "ppp" is on "etc/ppp/" 3-how can i go to the "kppp sub directory" and where? 4- Are these file or line " "-DCHAPMS" in the CFLAGS or COMPILE_FLAGS macro, and that the LIBS macro"
Do a "make clean" ????and then a "make" ????to rebuild ???? pppd. Assuming all goes well, install ????the new pppd and move on to the CONFIGURATION section.
On this part as it says i need to "make clean" and then " make". again 1- Where could i make " make clean"and "make" because i just wrote these command on the shell and it was sayin no target specified. How i can write the full command? (make clean " target" )? and again same question how and where could i make the "make" command in order to rebuild the pppd.?
P.S. I am trying to use SuSE 7.2 pro. Kernel is 2.4.4 GB My computer is Compaq 1800T Notebook. Any help appreciated in advance emin
-- To unsubscribe send e-mail to suse-linux-e-unsubscribe@suse.com For additional commands send e-mail to suse-linux-e-help@suse.com Also check the FAQ at http://www.suse.com/support/faq and the archives at http://lists.suse.com