I am have been unable to figure out where and when to setup the connection and mount for my netware server. I am able to do this in terminal after linux and xserver boots: # establishes the connection between the eth0 card # and my ipx ipx_configure --auto_interface=on --auto_primary=on # mounts the netware server to /mnt/FMG ncpmount -S FMG /mnt/FMG -U username -P password Where can I put these commands in order to have them executed at the end of the boot process and before (I presume) the xserver starts? Also, is there a way to prevent commands, like these, which normally interact with the console from doing so? I have been able to accomplish this on a user basis but I want these mounts to take place globally for all users. thanks, Otto Porter -- To unsubscribe send e-mail to suse-linux-e-unsubscribe@suse.com For additional commands send e-mail to suse-linux-e-help@suse.com Also check the FAQ at http://www.suse.com/support/faq