anyone got rarp working under 6.3? -- proud Linux user since kernel 1.1.54 icq#42235604 <STRONG>attached mail follows:</STRONG><HR> :)6.# /sbin/rarp -s client CC:CC:CC:CC:CC:CC :) If RARP is not compiled into your kernel, you will get one of :)the two following error messages: :) :) SIOCSRARP: Invalid argument :) :)does this mean that this error is normal or acceptable? or does this :)mean i CANNOT run rarp as a loaded module? This means that your linux machine is not running rarp. This is not acceptable, since you need rarp to boot your client. As to a loaded module or not, I don't know (perhaps you loaded it wrong or the rarp module doesn't work), but if rarp doesn't run (for whatever reason), you can't netboot a sparc client. :)btw, the client (classic) reports no error messages as indicated by the :)howto. Well, I based those error messages on the errors reported by my hp300 system. No doubt it's different for other platforms. Good luck, -- MW -- To unsubscribe send e-mail to suse-linux-e-unsubscribe@suse.com For additional commands send e-mail to suse-linux-e-help@suse.com Also check the FAQ at http://www.suse.com/support/faq