Leonard Ong wrote:
Hi,
I don't know abt you guys, please confrim this. My experience with 90x that i have to boot into dos, and use the 3c90xcfg.exe to program the NIC into non-PnP mode ( fixatated the IRQ and io addr ). After then with passing the predetermined irq and io to the kernel, the card will work fine.
Thanks
Please confirm
Bill Moseley wrote:
I read at these links that I should be using the 3Com driver for my 3c905C-TX NIC: http://cesdis.gsfc.nasa.gov/linux/drivers/vortex.html http://support.3com.com/infodeli/tools/nic/linuxdownloading.htm
The driver, 3c90x is in available on my 6.3 system. locate 3c90x.o /lib/modules/2.2.13/net/3c90x.o
So, I modified /etc/modules.conf like this:
fgrep 3c /etc/modules.conf #alias eth0 3c59x alias eth0 3c90x
and rebooted. But it still seems to use the old driver:
lsmod | fgrep 3c 3c59x 19008 1
Where else could that module be loaded? I find this confusing.
I have not built my own kernel. I do remember during the initial installation using Yast1 that I asked Yast to auto-detected my NIC, which it did. And now, looking at Yast->System admin->Integrate hardware into system->Configure networking device says: "3Com 3c90x/3c980 B/C series". Looks ok to me.
I'm wondering first why changing modules.conf didn't work, and then if using the new 3com driver will clear up this /var/log/messages error:
kernel: eth0: Transmit error, Tx status register 82.
And also I see this in the boot log:
<6>3c59x.c:v0.99L 5/28/99 Donald Becker http://cesdis.gsfc.nasa.gov/linux/drivers/vortex.html
<6>eth0: 3Com 3c905C Tornado at 0xd000, ***INVALID CHECKSUM 0027*** 00:50:da:d7:93:e9, IRQ 11
<6> 8K byte-wide RAM 5:3 Rx:Tx split, autoselect/Autonegotiate interface. <6> MII transceiver found at address 24, status 782d. <6> Enabling bus-master transmits and whole-frame receives.
Also, anyone using two of these NICs in one computer? I noticed this (anonymous) person claiming that more than one card doesn't work:
http://lhd.datapower.com/db/dispreport.cgi?DISP?875
Anyone know anything about that?
Thanks,
Bill Moseley mailto:moseley@hank.org
-- To unsubscribe send e-mail to suse-linux-e-unsubscribe@suse.com For additional commands send e-mail to suse-linux-e-help@suse.com Also check the FAQ at http://www.suse.com/Support/Doku/FAQ/
--
Regards, Leonard Ong Kristal Telecom
-- Regards, Leonard Ong Kristal Telecom -- To unsubscribe send e-mail to suse-linux-e-unsubscribe@suse.com For additional commands send e-mail to suse-linux-e-help@suse.com Also check the FAQ at http://www.suse.com/Support/Doku/FAQ/