I realize that this subject has been discussed extensively on this list. (I've been through the list archives) I have tried everything that has been posted and still to no avail. The display adapter that I am using is built in on a PCChips mother board, it is designated as "AGP" but the mother board has no AGP port. There is an entry in SaX for this card but I cannot get it to sync right. I used to be able to get this monitor to work at 1024x768 8bpp with a diamond stealth 3D 2000 but had to give it up when I built a computer for my mom. I have tried all the options i.e, no_bitblt, noaccel, and sw_cursor that were mentioned. I use the hsync and vsync values specified on the monitor specs I got from the IBM web site. I can't even get it to work in 640x480. SaX actually gives me a readable screen at that res but it is stretched vertically and narrowed horizontally. I would like to know if anyone could give me some help or at least point me in the right direction. I will be getting a new monitor and vid card, but not for awhile, and I don't want to wait to start using KDE again (I prefer the GUI to the console) B.T.W. I am running 6.2, I haven't upgraded or installed anything other than what comes on the cd's. If preferred, one can reply offlist to me at damianks@netnet.net Thanks in advance. -- To unsubscribe send e-mail to suse-linux-e-unsubscribe@suse.com For additional commands send e-mail to suse-linux-e-help@suse.com Also check the FAQ at http://www.suse.com/Support/Doku/FAQ/