I'm STILL, for the third or so day, trying to get SuSE to run right on my friend's laptop. The latest problem is on bootup, I'm getting "error while executing /sbin/route add default gw 134.x.x.x." So, I went into /etc/route.conf and commented out the line with the default gateway address. I'm not getting the error anymore, but I'm still not able to connect it to the network. With that line uncommented, it seems to load the card without incident. Previously I compiled a 2.2.14 kernel with Card Services 3.1.12. The procedure I used to make the kernel is: make xconfig make dep make clean make bzImage make modules make modules_install depmod -a Then I compiled CS 3.1.12 and booted the new kernel. It's a Digital HiNote VP725 P200MMX with 96MB RAM. The network card is a 3com 3c589_cs (used for a network install and worked fine before we installed the new version of CS. Problem before was that it wouldn't see the other slot.) It is in slot 0. Slot 1 holds an Adaptec APA-1480 SlimSCSI card. Any help, once again, would be appreciated. Thanks. _________________________ Joseph A. Hylkema josephhy@wsu.edu "Necessity is the plea for every infringement of human freedom. It is the argument of tyrants, it is the creed of slaves." William Pitt, 1783 Support a Husky-Free Northwest. GO COUGARS!!!!! -- To unsubscribe send e-mail to suse-linux-e-unsubscribe@suse.com For additional commands send e-mail to suse-linux-e-help@suse.com Also check the FAQ at http://www.suse.com/Support/Doku/FAQ/