3 Jan
2000
3 Jan
'00
18:40
Hello all, I installed a clean SuSE 6.3 onto my development system and am trying to get the network card working. The card is a RealTek 8029, which should use the ne2k-pci driver. Yast sets this up, but the driver is not loaded when the machine starts. If I enter modprobe ne2k-pci The module loads OK, and I can then enter lsmod and see it in the list. if I then enter ifconfig -a, I can see eth0 in the list of interfaces, but no addresses are specified, etc. Any ideas? Thanks, Ron Cordell -- To unsubscribe send e-mail to suse-linux-e-unsubscribe@suse.com For additional commands send e-mail to suse-linux-e-help@suse.com Also check the FAQ at http://www.suse.com/Support/Doku/FAQ/