I have a server with a single ethernet interface, eno1. When booting to kernel-default, the interface is configured in /etc/sysconfig/network/ifcfg-eno1 and gets brought up by the wicked networking stack If I switch to Xen, booting to kernel-xen, I can bring up the Dom0 in this configuration too. But for PV DomUs, I need a bridge interface to pass in vif=[...] I know how to create & configure the bridge interface (/etc/sysconfig/network/ifcfg-br0) to 'take over' eno1 I can't figure out how to create & use the bridge only conditionally -- in the Xen-boot case. In other words, if boot to non-Xen, use intfc "eno1" and, if boot to Xen, use intfc "br0" instead On my previous servers I'd use if-up & if-down scripts to handle it. The up/down scripts don't seem to work with the opensuse wicked stack. How do you handle conditional network configuration with wicked, depending on which boot environment -- Xen or non-Xen -- you're booting to? IIUC the advice has been to use opensuse networking config to setup the interfaces. To do this ^^ do you have to step outside the OS config? LT -- To unsubscribe, e-mail: opensuse-virtual+unsubscribe@opensuse.org To contact the owner, e-mail: opensuse-virtual+owner@opensuse.org