hi list yesterday I set up a vsftpd server - sucessfully ;-) all common connections (from the beloved redmond tools) make no problems. curiously the lukeftp command line tool has problems connecting the server. in standard mode all command which active the passive mode fails: 229 Entering Extended Passive Mode (|||46597|) ...here is dead end. after googeling I discover the epsv4 toggle mode. after disabling the extended passive commands, following server message appear: 227 Entering Passive Mode (XXX,XXX,XX,XX,23,72) that works quite good. curiously I can establish a connection to this ftp-server via VPN (and the private IP-Number). within my enterprise network the 229 - Extended Passive Mode works! therefore it is definitely not the fault of vsftpd. here comes my questions. 1) I assume the number "46579" is the port number given from the FTP server in the case of epsv. the ",23-72" is the range of data port given by FTP in case of pasv mode. is that correct? therefore one firewall seems blocking the high-port 46579 in the case of internet-connection (at VPN connection all traffice goes through..)?? 2) if I establish with lukeftp a connection to "ftp.suse.com" I am immediately in the pasv mode (instead epsv). I assume SuSE also running vsftpd - therefore a setting must exist which forces ftp-clients to use classical pasv mode. unfortunately I could not find this option. regards harald -- Mit freundlichen Grüßen / With kind regards Dipl.-Ing. Harald Nikolisin SOFiSTiK AG (Entwicklung)