Note on partitioning. I had previously mentioned that I didn't have any issues using YaST's partitioner in v10.0. However, I have since found that when you are installing onto a disk that aleady has MacOS on it and is booted from that disk, you do have to set the disk up w/ pdisk. IF you are using a seperate drive for openSuSE, the partitoner works so long as you do NOT use an Apple_HFS partition. Anyway, I installed v10.0 on my son's PowerBook G3(Wallstreet). I was hoping that the 466Mhz upgrade I had ordered would show today, but not yet. The system was able to successfully install using the G3/233(no back side cache).It is kinda slow, but it works. I used the "acceleratedx=1" command line option in BootX, and the graphical system works just fine using 15bit color. I'm hoping for a huge improvement with the new processor, and hopefully it will be able to play video with no problems. Later