Hi, I was able to complete a basic install of 7.3 on a new G4/800 (single processor) with an Apple 17" flat panel using yast2 (colors were messed up but useable). I was able to boot the new system without having to specify a kernel video parameter. Colors in X were messed up but useable. I then set run level 3 as the default until I could get XFree86 4.2.0 installed and working properly. The console worked fine (again, no kernel video parameter was needed). I then proceeded to upgrade to kernel 2.4.16 and modutils 2.4.11 as was mentioned in the following Support Database article: http://sdb.suse.de/en/sdb/html/ubrueck_ppc_G4radeon.html I then followed the instructions in the following Support Database article to get the radeon framebuffer going with my Apple 17" flat panel: http://sdb.suse.de/en/sdb/html/olh_ppc_apple_tft.html Unfortunately, I could not get any combination to work (monitor went black). I tried the following combinations: video=radeon:1280x1024-8@60 video=radeonfb:1280x1024-8@60 video=radeon:vmode:17 video=radeonfb:vmode:17 I also tried not specifying a video parameter but that also resulted in a black screen. I am able to get useable video with video=ofonly. I then proceeded to upgrade to XFree86 4.2.0 using RPMs found at: ftp://ftp.suse.com/pub/suse/ppc/supplementary/X/suse73/4.2.0 I could not find an xf86glu RPM there and there were no complaints during the upgrade so I still have the 4.1.0 version installed. I did try to uninstall it but a bunch of other packages depended on it. I then attempted to configure 4.2.0 using the following command as was mentioned in the first article above: # sax2 -m 0=fbdev Colors were messed up again but still useable. It didn't detect my video card and when I tried to specify it, the list of Radeon models provided did not include the 7500 (not too surprising since it is new). I didn't know what to do at that point so I aborted configuration and am now writing this message. Should I have any expectation of getting accelerated X working on this system with an ADC flat panel? I am replacing my current G4/466 with the G4/800 and will be sending the G4/466 and the Apple 17" flat panel to my parents. The G4/466 has a Rage 128 Pro card in it which is working fine with my Apple 22" Cinema Display (which I am keeping). If I will be unable to get the Radeon 7500 working, I plan to swap the cards between the two systems and keep the Rage 128 Pro. Ron