hello out there, i have lots of trouble trying to use my second eth interface under suse linux, both 6.4 and 7.1. this is concerning my home server (and every other mac i set up with suse linux 'til now) with the following unspectacular config: power mac 8200/120, one 1,2gb scsi hd (apple built in), one 4,5gb scsi hd (/home), 64 megs of ram (ok ok, it's not my g4 with 1gig ;), on board 10mbit eth (=eth0, works fine unless its pretty slow), one smc etherpower 10/100 (9432TX/MP) via the 'epic 100' module. (if i does work after your hints i guess i'll give it a second to manage nfs for my sun machine... ;) this seems to be pretty normal. everything works fine until you try to activate this smc card to work as the eth1 interface -- there's no difference trying device eth0 for the card. restarting the network (to enable eth1=smc) results in a hanging machine which is not only dead on the console, but also doesn't answer pings nor is reachable via telnet. you have to reset the machine. ***my question now is: did anyone successful use this card under (suse) linux?*** i tried to use this card on a power mac with netbsd -- no problem there... because it's a pretty good card, i think ;) tia for your answers and greetz, timo (aka Pansen)