Hallo, ich habe o.a. Brenner gekauft. Nach Formatieren eines DVD-RAM läuft dieses korrekt, (allerdings nur ca. 1.2 fach, statt 3-fach). Beim Brennen von CD's habe ich allerdings Probleme - da gab's auch schonmal bzgl. des Vorgängermodells ein "thread" - vielleicht war's das gleiche Problem, aber ich habe keine Lösung gefunden. --------------------------------------------------------------------------------- Sending CUE sheet... /usr/bin/cdrecord: WARNING: Drive returns wrong startsec (0) using -150 /usr/bin/cdrecord: Input/output error. write_g1: scsi sendcmd: no error CDB: 2A 00 FF FF FF 6A 00 00 1F 00 status: 0x2 (CHECK CONDITION) Sense Bytes: 70 00 05 00 00 00 00 10 2A 00 00 80 30 05 00 00 Sense Key: 0x5 Illegal Request, Segment 0 Sense Code: 0x30 Qual 0x05 (cannot write medium - incompatible format) Fru 0x0 Sense flags: Blk 0 (not valid) cmd finished after 0.003s timeout 200s /usr/bin/cdrecord: Input/output error. write_g1: scsi sendcmd: no error CDB: 2A 00 00 00 00 00 00 00 1F 00 status: 0x2 (CHECK CONDITION) Sense Bytes: 70 00 05 00 00 00 00 10 2A 00 00 80 30 05 00 00 Sense Key: 0x5 Illegal Request, Segment 0 Sense Code: 0x30 Qual 0x05 (cannot write medium - incompatible format) Fru 0x0 Sense flags: Blk 0 (not valid) cmd finished after 0.003s timeout 200s /usr/bin/cdrecord: A write error occured. /usr/bin/cdrecord: Please properly read the error message above. Writing pregap for track 1 at -150 write track pad data: error after 0 bytes BFree: 1176 K BSize: 1176 K Starting new track at sector: 0 Track 01: 0 of 601 MB written. write track data: error after 0 bytes ----------------------------------------------------------------------------------- Power calibration successful. /usr/bin/cdrdao: Input/output error. : scsi sendcmd: no error CDB: 2A 00 FF FF FF 6A 00 00 1A 00 status: 0x2 (CHECK CONDITION) Sense Bytes: 70 00 05 00 00 00 00 10 2A 00 00 80 30 05 00 00 Sense Key: 0x5 Illegal Request, Segment 0 Sense Code: 0x30 Qual 0x05 (cannot write medium - incompatible format) Fru 0x0 Sense flags: Blk 0 (not valid) cmd finished after 0.002s timeout 180s ERROR: Write data failed. ERROR: Writing failed. cdrdao comand: ----------------------- /usr/bin/cdrdao write --device 1,0,0 --driver generic-mmc:0x00000010 --speed 8 --overburn -n -v 2 --remote 22 /tmp/kde-wz/k3bxJOxGbtoc --------------------------------------------------------------------------------- Gruss Wolfgang