Ciao Christian & list readers,
On Wed, Jan 23, 2002 at 06:03:47AM +0100, Christian Zoz wrote:
Ich versuche eben zeit 1-2 Tage einen Netz mit Compaq desktops
+ WL110 Wlan karten (PCMCIA) + PCI Adapter zum laufen zu bringen,
aber auch leider ohne erfolg: alles scheint korrekt zu gehen
(erkennun, pcmcia start, ifconfig, iwconfig), aber dann gibt
es ständig "Tx errors", und ich kann nichts pingen. (alles unter suse7.3)
Ich meinte nur die Bridges.
Mit PCMCIA Karten hat alles funktioniert, ich hatte allerdings nur
Karten von Lucent, Elsa und Artem.
ok, aber PCMCIA + PCI Adapter (einsatz in desktop)?
Schick doch mal mehr Info: die pcmcia Meldungen in var/log/messages,
output von iwconfig und ifconfig.
ok, das wäre:
nach rcpcmcia start:
Jan 26 00:59:06 touch3 rcpcmcia: /sbin/insmod /lib/modules/2.4.10-4GB/pcmcia-external/pcmcia_core.o
Jan 26 00:59:06 touch3 kernel: Linux PCMCIA Card Services 3.1.28
Jan 26 00:59:06 touch3 kernel: kernel build: 2.4.10-4GB #1 Tue Sep 25 12:33:54 GMT 2001
Jan 26 00:59:06 touch3 kernel: options: [pci] [cardbus] [apm]
Jan 26 00:59:07 touch3 rcpcmcia: /sbin/insmod /lib/modules/2.4.10-4GB/pcmcia-external/i82365.o
Jan 26 00:59:07 touch3 kernel: Intel PCIC probe: PCI: Enabling device 00:0f.0 (0004 -> 0006)
Jan 26 00:59:07 touch3 kernel: PCI: Found IRQ 9 for device 00:0f.0
Jan 26 00:59:07 touch3 kernel:
Jan 26 00:59:07 touch3 kernel: TI 1410 rev 01 PCI-to-CardBus at slot 00:0f, mem 0x10000000
Jan 26 00:59:07 touch3 kernel: host opts [0]: [isa irq] [pci irq 9] [lat 66/176] [bus 2/5]
Jan 26 00:59:07 touch3 kernel: ISA irqs (default) = 3,4,7,10 PCI status changes
Jan 26 00:59:07 touch3 rcpcmcia: /sbin/insmod /lib/modules/2.4.10-4GB/pcmcia-external/ds.o
Jan 26 00:59:08 touch3 cardmgr[1396]: starting, version is 3.1.28
Jan 26 00:59:08 touch3 cardmgr[1396]: modpath = /lib/modules/2.4.10-4GB/
Jan 26 00:59:08 touch3 cardmgr[1396]: modsubdir = pcmcia-external
Jan 26 00:59:08 touch3 cardmgr[1396]: watching 1 sockets
Jan 26 00:59:08 touch3 cardmgr[1396]: initializing socket 0
Jan 26 00:59:08 touch3 kernel: cs: memory probe 0xa0000000-0xa0ffffff: clean.
Jan 26 00:59:08 touch3 cardmgr[1396]: socket 0: Intersil PRISM2 11 Mbps Wireless Adapter
Jan 26 00:59:08 touch3 cardmgr[1396]: executing: 'insmod -v /lib/modules/2.4.10-4GB//pcmcia-external/hermes.o'
Jan 26 00:59:08 touch3 cardmgr[1396]: + Using /lib/modules/2.4.10-4GB//pcmcia-external/hermes.o
Jan 26 00:59:08 touch3 cardmgr[1396]: + Symbol version prefix ''
Jan 26 00:59:08 touch3 kernel: hermes.c: 12 Dec 2000 David Gibson
Jan 26 00:59:08 touch3 cardmgr[1396]: executing: 'insmod -v /lib/modules/2.4.10-4GB//pcmcia-external/orinoco.o'
Jan 26 00:59:09 touch3 kernel: orinoco.c 0.07 (David Gibson and others)
Jan 26 00:59:09 touch3 cardmgr[1396]: + Using /lib/modules/2.4.10-4GB//pcmcia-external/orinoco.o
Jan 26 00:59:09 touch3 cardmgr[1396]: + Symbol version prefix ''
Jan 26 00:59:09 touch3 cardmgr[1396]: executing: 'insmod -v /lib/modules/2.4.10-4GB//pcmcia-external/orinoco_cs.o'
Jan 26 00:59:09 touch3 kernel: dldwd: David's Less Dodgy WaveLAN/IEEE Driver
Jan 26 00:59:09 touch3 kernel: orinoco_cs.c 0.06 (David Gibson and others)
Jan 26 00:59:09 touch3 cardmgr[1396]: + Using /lib/modules/2.4.10-4GB//pcmcia-external/orinoco_cs.o
Jan 26 00:59:09 touch3 cardmgr[1396]: + Symbol version prefix ''
Jan 26 00:59:09 touch3 kernel: cs: IO port probe 0x0100-0x04ff: excluding 0x158-0x15f 0x220-0x22f 0x268-0x26f 0x330-0x337 0x378-0x37f 0x388-0x38f
0x4d0-0x4d7
Jan 26 00:59:09 touch3 kernel: cs: IO port probe 0x0160-0x021f: clean.
Jan 26 00:59:09 touch3 kernel: cs: IO port probe 0x0230-0x0267: clean.
Jan 26 00:59:09 touch3 kernel: cs: IO port probe 0x0270-0x032f: clean.
Jan 26 00:59:09 touch3 kernel: cs: IO port probe 0x0338-0x0377: clean.
Jan 26 00:59:09 touch3 kernel: cs: IO port probe 0x0380-0x0387: clean.
Jan 26 00:59:09 touch3 kernel: cs: IO port probe 0x0390-0x04cf: clean.
Jan 26 00:59:09 touch3 kernel: cs: IO port probe 0x04d8-0x04ff: clean.
Jan 26 00:59:09 touch3 kernel: cs: IO port probe 0x0800-0x08ff: clean.
Jan 26 00:59:09 touch3 kernel: cs: IO port probe 0x0a00-0x0aff: clean.
Jan 26 00:59:09 touch3 kernel: cs: IO port probe 0x0c00-0x0cff: excluding 0xc00-0xc07 0xc50-0xc57 0xc70-0xc77 0xc80-0xc87
Jan 26 00:59:09 touch3 kernel: cs: IO port probe 0x0c58-0x0c6f: clean.
Jan 26 00:59:09 touch3 kernel: cs: IO port probe 0x0c78-0x0c7f: clean.
Jan 26 00:59:09 touch3 kernel: cs: IO port probe 0x0c88-0x0cff: clean.
Jan 26 00:59:09 touch3 kernel: eth1: Firmware ID 1F vendor 0x1 (Lucent) version 6.16
Jan 26 00:59:09 touch3 kernel: eth1: Ad-hoc demo mode supported.
Jan 26 00:59:09 touch3 kernel: eth1: IEEE standard IBSS ad-hoc mode supported.
Jan 26 00:59:09 touch3 kernel: eth1: WEP supported, "128"-bit key.
Jan 26 00:59:09 touch3 kernel: eth1: MAC address 00:02:A5:2D:50:DF
Jan 26 00:59:09 touch3 kernel: eth1: Station name "HERMES I"
Jan 26 00:59:09 touch3 kernel: eth1: ready
Jan 26 00:59:09 touch3 kernel: eth1: index 0x01: Vcc 5.0, irq 3, io 0x0100-0x013f
Jan 26 00:59:09 touch3 cardmgr[1396]: executing: './network start eth1'
Jan 26 00:59:19 touch3 kernel: NET4: Linux IPX 0.47 for NET4.0
Jan 26 00:59:19 touch3 kernel: IPX Portions Copyright (c) 1995 Caldera, Inc.
Jan 26 00:59:19 touch3 kernel: IPX Portions Copyright (c) 2000, 2001 Conectiva, Inc.
Jan 26 00:59:19 touch3 kernel: NET4: G4KLX/GW4PTS AX.25 for Linux. Version 0.37 for Linux NET4.0
Jan 26 00:59:19 touch3 kernel: NET4: AppleTalk 0.18a for Linux NET4.0
Sieht hier bis jetzt alles ok aus!
und hier nach ifconfig und pings (Tx timeout kommt auch ohne pings):
Jan 26 00:59:47 touch3 kernel: NETDEV WATCHDOG: eth1: transmit timed out
Jan 26 00:59:47 touch3 kernel: eth1: Tx timeout! Resetting card.
Jan 26 00:59:50 touch3 kernel: eth1: no IPv6 routers present
Jan 26 00:59:55 touch3 kernel: NETDEV WATCHDOG: eth1: transmit timed out
Jan 26 00:59:55 touch3 kernel: eth1: Tx timeout! Resetting card.
Jan 26 01:00:03 touch3 kernel: NETDEV WATCHDOG: eth1: transmit timed out
Jan 26 01:00:03 touch3 kernel: eth1: Tx timeout! Resetting card.
Jan 26 01:00:11 touch3 kernel: NETDEV WATCHDOG: eth1: transmit timed out
Jan 26 01:00:11 touch3 kernel: eth1: Tx timeout! Resetting card.
Jan 26 01:00:45 touch3 su: (to nobody) root on none
touch3:~ # rcpcmcia start
Starting external PCMCIA (using scheme: SuSE) done
touch3:~ # iwconfig eth1
eth1 IEEE 802.11-DS ESSID:"" Nickname:"HERMES I"
Mode:Managed Frequency:2.457GHz Access Point: 00:00:00:00:00:00
Bit Rate:2Mb/s Tx-Power=15 dBm Sensitivity:1/3
Retry limit:4 RTS thr:off Fragment thr:off
Encryption key:off
Power Management:off
Link Quality:0/92 Signal level:-102 dBm Noise level:-102 dBm
Rx invalid nwid:0 invalid crypt:0 invalid misc:0
touch3:~ # iwconfig eth1 essid ima
touch3:~ # iwconfig eth1
eth1 IEEE 802.11-DS ESSID:"" Nickname:"HERMES I"
Mode:Managed Frequency:2.457GHz Access Point: 00:00:00:00:00:00
Bit Rate:2Mb/s Tx-Power=15 dBm Sensitivity:1/3
Retry limit:4 RTS thr:off Fragment thr:off
Encryption key:off
Power Management:off
Link Quality:0/92 Signal level:-102 dBm Noise level:-102 dBm
Rx invalid nwid:0 invalid crypt:0 invalid misc:0
touch3:~ # ifconfig eth1 192.168.0.25 netmask 255.255.255.0 up
(Zyxel access point ausgeschaltet)
touch3:~ # iwconfig eth1
eth1 IEEE 802.11-DS ESSID:"ima" Nickname:"HERMES I"
Mode:Managed Frequency:2.457GHz Access Point: 44:44:44:44:44:44
Bit Rate:2Mb/s Tx-Power=15 dBm Sensitivity:1/3
Retry limit:4 RTS thr:off Fragment thr:off
Encryption key:off
Power Management:off
Link Quality:0/92 Signal level:-102 dBm Noise level:-102 dBm
Rx invalid nwid:0 invalid crypt:0 invalid misc:0
(access point eingeschaltet:)
touch3:~ # iwconfig eth1
eth1 IEEE 802.11-DS ESSID:"ima" Nickname:"HERMES I"
Mode:Managed Frequency:2.457GHz Access Point: 00:A0:C5:15:02:D0
Bit Rate:2Mb/s Tx-Power=15 dBm Sensitivity:1/3
Retry limit:4 RTS thr:off Fragment thr:off
Encryption key:off
Power Management:off
Link Quality:57/92 Signal level:-35 dBm Noise level:-92 dBm
Rx invalid nwid:0 invalid crypt:0 invalid misc:0
touch3:~ # ping 192.168.0.200
PING 192.168.0.200 (192.168.0.200) from 192.168.0.136 : 56(84) bytes of data.
--- 192.168.0.200 ping statistics ---
10 packets transmitted, 0 received, 100% loss, time 0ms
-> interessant ist dass er die MAC adresse von AP doch findet, aber
dann nichts schicken kann. Unt Bit Rate ist kurz nach dem ifconfig auf
11Mb/s, aber dann sofort 2Mb/s.
Wie gesagt, unter w2k lauft alles bestens und 11Mbit (entfernung: 2-3 m).
Feedback *herzlich* willkommen... :)
Olivier
--
_________________________________________________________________
Olivier Mueller - om@8304.ch - PGPkeyID: 0E84D2EA - Switzerland
qmail projects: http://omail.omnis.ch - http://webmail.omnis.ch
