hi, Martin Marschand schrieb:
Dann schau Dir mal das Script I4l_hardware genauer an, es gab da mal eines da waren die Einträge für die AVM Kareten alles auskommentiert
ok es war alles auskommentiert in i4l_hardware. nun aber gibts fehler: --- /sbin/insmod /lib/modules/2.4.0-4GB/kernel/drivers/isdn/avmb1/isdn.o Using /lib/modules/2.4.0-4GB/kernel/drivers/isdn/avmb1/isdn.o Symbol version prefix '' /sbin/insmod /lib/modules/2.4.0-4GB/kernel/drivers/isdn/avmb1/capidrv.o Using /lib/modules/2.4.0-4GB/kernel/drivers/isdn/avmb1/capidrv.o Loading AVM-B1 firmware to Controller 1 ... Loading Bootcode /usr/lib/isdn/b1.t4 ... ioctl LOAD: Device or resource busy avmcapictrl: please also look at the kernel message, call command dmesg(8) Loading of Firmware /usr/lib/isdn/b1.t4 on Controller 1 failed! --- dmesg schmeisst raus: --- CAPI-driver Rev 1.22 : loaded capifs: Rev 1.16 : loaded capi20: started up with major 68 kcapi: capi20 attached capi20: Rev1.49: started up with major 68 (middleware+capifs) b1: revision 1.24 b1pci: revision 1.36 kcapi: driver b1pci attached PCI: Found IRQ 11 for device 00:0b.0 b1pci: PCI BIOS reports AVM-B1 V4 at i/o 0xb800, irq 11, mem 0xe1800000 kcapi: Controller 1: b1pci-b800 attached b1pci: AVM B1 PCI V4 at i/o 0xb800, irq 11, revision 4 (no dma) b1pci: 1 B1-PCI card(s) detected b1pci-b800: card 1 "B1" ready. b1pci-b800: card 1 Protocol: DSS1 b1pci-b800: card 1 Linetype: point to point b1pci-b800: B1-card (3.09-10) now active kcapi: card 1 "b1pci-b800" ready. kcapi: notify up contr 1 capi: controller 1 up ISDN subsystem Rev: 1.114/1.94/1.140.6.1/1.85/1.21/1.5 loaded kcapi: capidrv attached kcapi: appl 1 up capidrv-1: now up (2 B channels) capidrv-1: D2 trace enabled capidrv: Rev 1.39 : loaded kcapi: load: contr=1 not in detect state --- woran kann das liegen ? ciao sascha