Moin Moin! Ich kämpfe immernoch mit kimon! Ich beschreibe mal wie es aussieht: Ich rufe von einem x-term aus kimon auf und bekomme die Fehlermeldung: "ippp0: Invalid argument" Zu meiner ISDN-Konfiguration: desktop:~ # ifconfig ippp0 ippp0 Link encap:Ethernet HWaddr FC:FC:C0:A8:00:63 inet addr:192.168.0.99 P-t-P:192.168.0.1 Mask:255.255.255.255 UP POINTOPOINT RUNNING NOARP DYNAMIC MTU:1500 Metric:1 RX packets:0 errors:0 dropped:0 overruns:0 frame:0 TX packets:0 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:30 desktop:~ # isdnctrl list all Current setup of interface 'ippp0': EAZ/MSN: 4822971 Phone number(s): Outgoing: Incoming: Dial mode: off Secure: off Callback: off Reject before Callback: on Callback-delay: 2 Dialmax: 2 Hangup-Timeout: 60 Incoming-Hangup: off ChargeHangup: off Charge-Units: 0 Charge-Interval: 0 Layer-2-Protocol: hdlc Layer-3-Protocol: trans Encapsulation: rawip Slave Interface: None Slave delay: 10 Slave trigger: 6000 cps Master Interface: None Pre-Bound to: Nothing PPP-Bound to: 0 Ich habe als ppp0 meinen DSL-Anschluß und brauche also mit ISDN keine ppp-Verbindung. Ich möchte lediglich sehen, ob die B-Kanäle belegt sind und mir dann später auch aneigen lassen wer gerade anruft bzw. angerufen hat. Weiß jemand von Euch was ich mit kimon falsch mache? Gruß und Danke Thilo