I noticed some output from a routine zypper update to a tumbleweed installation tday and was wondering if the messages from dracut are benign or point to a missing set of dependencies? Trimmed utput below: ... (103/104) Installing: kernel-default-4.4.1-4.1.g4dac1be ...................................................................................[done] Additional rpm output: Creating initrd: /boot/initrd-4.4.1-4.g4dac1be-default dracut: Executing: /usr/bin/dracut --logfile /var/log/YaST2/mkinitrd.log --force /boot/initrd-4.4.1-4.g4dac1be-default 4.4.1-4.g4dac1be-default dracut: dracut module 'multipath' will not be installed, because command 'multipath' could not be found! dracut: dracut module 'fcoe-uefi' will not be installed, because command 'dcbtool' could not be found! dracut: dracut module 'fcoe-uefi' will not be installed, because command 'fipvlan' could not be found! dracut: dracut module 'fcoe-uefi' will not be installed, because command 'lldpad' could not be found! dracut: dracut module 'multipath' will not be installed, because command 'multipath' could not be found! dracut: dracut module 'fcoe-uefi' will not be installed, because command 'dcbtool' could not be found! dracut: dracut module 'fcoe-uefi' will not be installed, because command 'fipvlan' could not be found! dracut: dracut module 'fcoe-uefi' will not be installed, because command 'lldpad' could not be found! dracut: *** Including module: bash *** ... Thanks, Daniel -- To unsubscribe, e-mail: opensuse-factory+unsubscribe@opensuse.org To contact the owner, e-mail: opensuse-factory+owner@opensuse.org