Hello, I just "zypper dup -l" on a laptop (netbook, in fact) and have problem It's a very old install that run without (major) problem since factory 6 month ago, regularly upgraded I didn't use it for nearly 3/4 weeks, so don't know what was the previous install. now with RC2, I can boot init 1, but not init 3, and issuing init 3 after boot make the computer stop accepting keyboard input (but it's not crashed as pressing the switch makes it close gracefully). The network connection is through wlan, this may be the problem. Starting the network simply give nothing - the status is 'active (exited)", but ifconfig do not show any interface apart lo the update was made through wlan, so I know it should work :-) looking at dmesg, I see only eth2 is tried and of course don't work (not connected). launching yast, I'm warned I have to use network manager, but don't know howto do this from init 1 :-( so revert to traditional ifup. going to wlan, I notice I have a fixed IP 89.234.168.110 / 21 (why 21?) I do not remember to have ever setup - but I may have done it and forgotten like this the wlan is up, but do not get any IP from dhcp. I notice also that the wlan led is not lit I beg I have to find some wired connection ideas? thanks jdd -- To unsubscribe, e-mail: opensuse-factory+unsubscribe@opensuse.org To contact the owner, e-mail: opensuse-factory+owner@opensuse.org