I have a Athlon64 dual core in a MSI K9A PLATINUM motherboard, and for instaling OSS 10.2, I must to install with "install pci=nomsi" in the command line. Later I upgrade it to OSS 10.3 alpha 6, and it works without important problems (32 bit version) But now I downloaded the kde x86-64 iso, verified the checksum, it was ok, and it will not install on my SB600 / RD580 based motherboard. The hard disk is a WD SATA2. I tryed with safe settings, acpi off, and with "install pci=nomsi", but the ahci module will not load. The bios is setted to "Native IDE", but it was the same in 10.2 and 10.3 alpha 6 if it was setted to "ahci". Other detail, after the upgrade to 10.3 alpha 6, I changed the dvd burner from a Asus ATAPI, to a LITE-ON DVDRW LH-20A1H (20x burning dvds), and I must to change the driver from the ide-generic to pata_atiixp, to lograte that it works with k3b. In the installation proces hte system stpops for about 2 minutes trying to load de ahci driver module (in 10.2 32 bits I got the same problem without the "install pci=nomsi" in the command line), but this option will not work now in 10.3 beta1 X86-64. Now the loaded modules for the disk controllers with 10.3 alpha 6 32 bits are: pata_atiixp 11904 0 ahci 25348 4 libata 120396 2 pata_atiixp,ahci scsi_mod 140248 5 usb_storage,sr_mod,sg,sd_mod,libata Regards --------------------------------------------------------------------- To unsubscribe, e-mail: opensuse-factory+unsubscribe@opensuse.org For additional commands, e-mail: opensuse-factory+help@opensuse.org