Prueba con esto: Desktop Boards Resolving Slow Boot Times [] Extended boot time can be the result of IDE drive jumper configuration. Check the jumper setting on your IDE drives attached to the same channel/cable and verify the drives are properly configured according to manufacturer's recommendations. If it is the only drive on the cable, configurations can vary depending on manufacturer. Some should be configured for Master or Single; other drives may need the jumper removed. With two IDE devices on a channel, one needs to have the jumpers configured for Master and the other to Slave. For best performance with a single IDE device on a channel, the drive should be connected to the end of the cable and configured for Single. Another option is to jumper for Cable-Select and connect the drive to the Master (black) connector on the cable. Other things to check: * Ensure that Intel® Rapid BIOS boot is selected in the system BIOS setup. * Ensure that your hard drive is the first device in boot order in the system BIOS setup. * If you are not using certain functions, you may consider disabling them. Some examples include: * Legacy USB * This is needed if you use a USB keyboard or USB mouse. If not, then you may disable this in the system BIOS setup. * Unused I/O ports; such as serial and parallel ports * If you are not using these ports, they can be disabled in the system BIOS setup. * Event logging http://www.intel.com/support/motherboards/desktop/sb/CS-009044.htm
Hola, seria de mucha ayuda, que al igual que en cualquier caso en que alguien solicite asistencia, incluya por ejemplo si ya reviso los archivos de Logs de Arranque, y de ser asi, si encontro algo anormal...
o que monitoree en tiempo de arranque, los mensajes de texto que se despliegan en la consola de salida de msgs, ya que pueden ser mil cien razones por las cuales se le este presentando este problema, pero, si solo expones el problema sin mayor detalle, va a estar relativamente dificil que alguien te pueda asistir.
--ed
OK. Tienes razón, pero lo extraño del caso es que no hay una localización concreta del problema, por eso simplemente comentaba lo del arranque y lo del comando man. Es un problema general de rendimiento, los comandos que antes eran inmediatos (man, rpm -qpil Archivo, etc...) ahora tardan varios segundos en procesarse y los que tardaban varios segundos, como udev al crear los dispositivos ahora tarda varios minutos, pero no logro detectar un cuello de botella específico... por eso preguntaba por problemas de rendimiento similares.
Lo cierto es que hace tiempo que vengo sospechando del módulo que controla el sistema de RAID, así que probaré a actualizar a 9.3 y ver lo que pasa.
Pero ya que estamos... ¿Alguien sabe como mirar que CPU consume un módulo? Algo así como top pero para los módulos del kernel, aunque sea de manera aproximada.
Y para los morbosos del hardware... ;-) La placa RAID es una Intel SRCS14L (true raid por hardware), la placa base es una D915GAV y los discos duros dos Seagate de 160 Gb a 7200 rpm con una tasa de transferencia de 1,5 Gb/s. montados en RAID 1.
Saludos y gracias.
Rafa.
-- Para dar de baja la suscripción, mande un mensaje a: suse-linux-s-unsubscribe@suse.com Para obtener el resto de direcciones-comando, mande un mensaje a: suse-linux-s-help@suse.com
--ed He who fights with monsters might take care lest he thereby become a monster. And if you gaze for long into an abyss, the abyss gazes also into you .Friedrich Nietzsche, Beyond Good and Evil, Aphorism 146