Henne Vogelsang wrote:
2. wie kann ich die Karte dauerhaft auf 100MBit Fullduplex einstellen?
mii-tool/ethtool
ich habe ethtool installiert, aber es funktioniert nicht: linux:/opt/install/ethtool-1.8 # ./ethtool -s eth0 autoneg off linux:/opt/install/ethtool-1.8 # ./ethtool -s eth0 speed 100 linux:/opt/install/ethtool-1.8 # ./ethtool eth0 Settings for eth0: Supported ports: [ TP MII ] Supported link modes: 10baseT/Half 10baseT/Full 100baseT/Half 100baseT/Full Supports auto-negotiation: Yes Advertised link modes: 10baseT/Half 10baseT/Full 100baseT/Half 100baseT/Full Advertised auto-negotiation: Yes Speed: 10Mb/s Duplex: Half Port: MII PHYAD: 32 Transceiver: internal Auto-negotiation: on Supports Wake-on: pumbg Wake-on: d Current message level: 0xffffffff (-1) Link detected: no linux:/opt/install/ethtool-1.8 #
4. Die Verbindung über die Netzwerkkarte funktioniert nicht mehr, sobald ich mich mit dem externen ISDN-Modem ins Internet einwähle. Ist das normal oder ist bei mir was falsch eingestellt?
Kommt drauf an. Wahrscheinlich legt i4l die routen um. Leg mal die Netzwerkkarte und die ISDN Karte in unterschiedliche Netze.
wie geht das? Gruss Ralf