Am Die, 12 Feb 2002 schrieb Softwareentwicklung Hauschel:
Was um Himmels Willen muß ich tun um Linux automatisch zu starten ? Ich habe im Control-Center/Yast2 Modules/System/Bootloader Konfiguration Instalationsziel ... für lilo -> MBR Abschnitte: /boot/vmlinuz
Control-Center/Yast2 Modules/System/Configure boot mode
Auf C:\ (MBR der ersten Platte)
Sag bloß, da steht in Yast2 C:\ Ich hoffe, daß das nicht wahr ist (ich habe Yast2 nie gemocht, aber das würde ihm die Krone aufsetzen) Schau mal in /etc/lilo.conf. Da sollte stehen boot = /dev/hda evtl. auch hde, hängt von Board/Controller ab. Wenn nicht ändere es, und rufe /sbin/lilo auf.
Wenn ich auf weiter klicke, sagt er mir LILO wurde auf Festplatte geschrieben....
ABER DIE SAU BOOTET NICHT !!!
--> Not found any active Partition in HDD --> DISK BOOT FAILURE...
Was mach ich falsch ?
Wie der Rechner schon sagt, es gibt keine aktive Partition auf der HD, mache die gewünschte primäre Part. aktiv, geht AFAIK z.B. mit fdisk. Gruß Christoph -- Christoph Maurer - 52072 Aachen - Tux#194235 mailto:christoph-maurer@gmx.de - http://www.christophmaurer.de Auf der Homepage u.a.: Installation von SuSE 7.0 auf Notebook Acer Travelmate 508 T, Elektrotechnik an der RWTH Aachen