Hallo Bodo, es gibt die Möglichkeit denm LILO mitzuteilen,wie er die Platten durchzunummerieren hat, damit kannst du die von dir gewünschte und funktionierende Reihenfolge anpassen - dann klappts wohl auch bei deiner Konfiguration. Schau mal in der manpage von lilo.conf unter disk,geometry nach : Hier schonmal ein Auszug: --- schnipp ---- 486dx66:~ # man lilo.conf disk=<device-name> Defines non-standard parameters for the specified disk. See section "Disk geometry" of user.tex for details. Especially useful is the `bios=' parame ter. The BIOS numbers your disks 0x80, 0x81, etc. and it is impossible to decide which Linux disk corresponds to which BIOS disk (since this depends on the BIOS setup, and on the type of BIOS), so if you have an unusual setup you need to state the correspondence between Linux disks and BIOS disks. For example, disk=/dev/sda bios=0x80 disk=/dev/hda bios=0x81 would say that your SCSI disk is the first BIOS disk, and your (primary master) IDE disk is the second BIOS disk. --- schnipp ---- hth Harry