https://bugzilla.novell.com/show_bug.cgi?id=851769 https://bugzilla.novell.com/show_bug.cgi?id=851769#c0 Summary: YaST Network - bridge br0 config not read properly Classification: openSUSE Product: openSUSE 13.1 Version: Final Platform: x86-64 OS/Version: openSUSE 13.1 Status: NEW Severity: Major Priority: P5 - None Component: YaST2 AssignedTo: bnc-team-screening@forge.provo.novell.com ReportedBy: horacius@horacius.cz QAContact: jsrain@suse.com Found By: --- Blocker: --- User-Agent: Mozilla/5.0 (Windows NT 5.1; rv:25.0) Gecko/20100101 Firefox/25.0 Just after the new installation, the configuration of "br0" not re-read by YaST, a "bridge" without a name appears. The bridge interface cannot be set, the last folder is "hardware" instead of "bridged devices". If the settings done during installation process, it is well configured, until using of the YaST-network module first time, (then the configuration is damaged if saved even "as is"). Reproducible: Always Steps to Reproduce: 1. New installation of openSUSE 12.3 2. Install hypervisor for using of XEN (via YaST virtualization module) 3. Open YaST network module to see the network devices and bridge (mis)configuration Actual Results: Network interfaces cannot be edited and configured using YaST network module. Expected Results: Configurable network interfaces using YaST network module. -- Configure bugmail: https://bugzilla.novell.com/userprefs.cgi?tab=email ------- You are receiving this mail because: ------- You are on the CC list for the bug.