https://bugzilla.novell.com/show_bug.cgi?id=848803 https://bugzilla.novell.com/show_bug.cgi?id=848803#c0 Summary: Ethernet card has duplicate configurations, "ifup" does not work (on new install) Classification: openSUSE Product: openSUSE 12.3 Version: Final Platform: x86-64 OS/Version: SUSE Other Status: NEW Severity: Normal Priority: P5 - None Component: Network AssignedTo: bnc-team-screening@forge.provo.novell.com ReportedBy: nrickert@ameritech.net QAContact: qa-bugs@suse.de Found By: --- Blocker: --- User-Agent: Mozilla/5.0 (X11; Linux x86_64; rv:24.0) Gecko/20100101 Firefox/24.0 This is from an install of 13.1RC2 today. I installed with manual configuration. The network config page showed a WiFi card, and two ethernet cards which looked identical. As far as I know, this computer has only one ethernet card. I accepted the defaults. The network failed to start (network tests during configuration). Backing up, I switched to NetworkManager, and then the network test succeeded. Other relevant information: During install, I configured the installer to also use online repos. Perhaps that is related (since it uses the network) The ethernet card entries appear to have device names: "enp4s0" and "p5p1". The error message after network tests was a failure on "enp4s0". NetworkManager is successfully use "p5p1". Opensuse 12.3 on this box is using "p5p1". My guess is that if I go into network settings and delete "enp4s0", that will correct the problem. But I have not tried this. Reproducible: Didn't try Steps to Reproduce: 1. 2. 3. -- Configure bugmail: https://bugzilla.novell.com/userprefs.cgi?tab=email ------- You are receiving this mail because: ------- You are on the CC list for the bug.