http://bugzilla.novell.com/show_bug.cgi?id=586837
http://bugzilla.novell.com/show_bug.cgi?id=586837#c6
--- Comment #6 from Dennis Olsson 2010-04-12 21:10:03 CEST ---
Sorry, Michal, but using the newest packages from the mentioned repository in
comment #16 in bug #589676#c16 does not fix the problem.
I tried to do an installation yesterday using the "openSUSE 11.3 Milestone 2
DVD" as base and
"http://download.opensuse.org/repositories/Base:/System/openSUSE_Factory/" as
add-on product.
The resulting system was (as expected) using "mdadm-3.0.3-22.1" and
"udev-151-30.2".
But this system still results in ending up with using "/dev/sdb3" over
"/dev/md127p3", when activating the LVM.
It also seems that the activation of the MD device does not do, what it is
supposed to do.
As far as I can see (although I currently cannot firmly confirm this - see
below), it seems that the activation of the MD device only activates the
"/dev/sda" part of the MD raid1 configuration ignoring the "/dev/sdb" disk.
This behaviour is consistent with a "mdadm -A --scan", whereas when a
mdadm -E --scan >/etc/mdadm.conf
mdadm -A --scan -c /etc/mdadm.conf
does a correct assembly of the MD raid1 device!
I was using the following disk configuration (see also bug #586837 c#0):
"/dev/sda" and "/dev/sdb" as physical disks.
"/dev/md/raid1" configured out of "/dev/sda" and "/dev/sdb".
Partitioned "/dev/md/raid1" with 3 partitions:
"/dev/md/raid1p1" as "ext3" file system mounted as "/boot" using
LABEL="boot113"
"/dev/md/raid1p2" as "swap" partition with priority 10 using LABEL="resumep10"
"/dev/md/raid1p3" as LVM volume named "raid1"
LVM configured with:
"/dev/raid1/root113" as "ext4" file system mounted as "/" using LABEL="root113"
I am unfortunately not able to supply you with any outputs, while after the
system has rebooted into the YaST installation console, the system freezes up
ignoring *any* keys from the keyboard -- only a power off is possible!
Also, when trying to reboot the system after the power off, each time the
system gets to the point, where the graphic is running, *all* keyboard activity
is *ignored*!
What I do see, though, is that the system is complaining about the device
mapper has already been activated and that the LVM is preferring "/dev/sdb3"
over "/dev/md127p3", which most likely is due to the fact that the MD device
was wrongly configured (the "/dev/sdb" is missing in the MD device).
--
Configure bugmail: http://bugzilla.novell.com/userprefs.cgi?tab=email
------- You are receiving this mail because: -------
You are on the CC list for the bug.