https://bugzilla.novell.com/show_bug.cgi?id=337003#c7
--- Comment #7 from Bernard Delley 2007-11-08 06:34:50 MST ---
overheating?
sensors works with 10.3 for this hardware. great!
while the program is running on all 4 processors, sensors indicates temperature
of 78 - 81 on the four processors (single chip, but each CPU has a reading)
the processor cooler felt quite warm by hand, when I tried.
the passive northgate cooler is quite warm (hot) judged by hand.
the machine is on the lowest floor on the shelf in a cooled room,
for extra reserve the side panel remains removed.
the smartd readings in /var/log/messages showing a maximum of 110 could that be
a
correct reading of northgate (ICH9 bridge) temperature?
the mention of Dmol39m90m in dmesg is indicative??
this is my user program that I to run in MPICH2 parallel mode.
Does the dmesg suggest it was involved in a crash previous to the reboot?
If there were any segmentation violations coming from a user program:
that should crash the program, but not the system.
--
Configure bugmail: https://bugzilla.novell.com/userprefs.cgi?tab=email
------- You are receiving this mail because: -------
You are on the CC list for the bug.