https://bugzilla.novell.com/show_bug.cgi?id=257303 ciriarte@personal.net.py changed: What |Removed |Added ---------------------------------------------------------------------------- Component|KDE |Hotplug ------- Comment #1 from ciriarte@personal.net.py 2007-03-25 20:42 MST ------- Ok, found out it's not a kde problem, i'm having problem on command line too: ciro@roamer:~> hciconfig -a hci0: Type: USB BD Address: 00:16:CF:FA:56:15 ACL MTU: 1017:8 SCO MTU: 64:1 UP RUNNING RX bytes:163 acl:0 sco:0 events:21 errors:0 TX bytes:334 acl:0 sco:0 commands:21 errors:0 Features: 0xff 0xff 0x8f 0xfe 0x9b 0xf9 0x00 0x80 Packet type: DM1 DM3 DM5 DH1 DH3 DH5 HV1 HV2 HV3 Link policy: RSWITCH HOLD SNIFF PARK Link mode: SLAVE ACCEPT Can't read local name on hci0: Input/output error (5) <----- It's solved doing a reset ciro@roamer:~> sudo hciconfig hci0 reset ciro's password ciro@roamer:~> hciconfig -a hci0: Type: USB BD Address: 00:16:CF:FA:56:15 ACL MTU: 1017:8 SCO MTU: 64:1 UP RUNNING PSCAN ISCAN RX bytes:579 acl:0 sco:0 events:42 errors:0 TX bytes:664 acl:0 sco:0 commands:42 errors:0 Features: 0xff 0xff 0x8f 0xfe 0x9b 0xf9 0x00 0x80 Packet type: DM1 DM3 DM5 DH1 DH3 DH5 HV1 HV2 HV3 Link policy: RSWITCH HOLD SNIFF PARK Link mode: SLAVE ACCEPT Name: 'BlueZ (none) (0)' Class: 0x3e0100 Service Classes: Networking, Rendering, Capturing, Object Transfer, Audio Device Class: Computer, Uncategorized HCI Ver: 2.0 (0x3) HCI Rev: 0x2128 LMP Ver: 2.0 (0x3) LMP Subver: 0x41d8 Manufacturer: Broadcom Corporation (15) Then, kbluetoothd responds again, but i should do it in every boot. How should i solve it? (i would prefer a nicer solution than using /etc/init.d/boot.local) -- Configure bugmail: https://bugzilla.novell.com/userprefs.cgi?tab=email ------- You are receiving this mail because: ------- You are on the CC list for the bug, or are watching someone who is.