https://bugzilla.novell.com/show_bug.cgi?id=230326 jsmeix@novell.com changed: What |Removed |Added ---------------------------------------------------------------------------- Status|NEW |RESOLVED Resolution| |WORKSFORME ------- Comment #2 from jsmeix@novell.com 2006-12-22 02:16 MST ------- You wrote "tried http://localhost:631/printers. Now there is a page with my printer but the page looks very strange, no pictures, no buttons" which indicates a somehow messed up CUPS installation. I know about such problems when a new CUPS installation is used with an old /etc/cups/cupsd.conf file (e.g. after an CUPS update from a older version). In particular because since openSUSE 10.2 we have CUPS 1.2.x which is somewhat incompatible to CUPS 1.1.x which we has before, I recomend to use the original /etc/cups/cupsd.conf from our CUPS 1.2 packages and not an old one. Your /var/log/cups/error_log shows the following errors: (use "grep ^E /var/log/cups/error_log"): ---------------------------------------------------------------------------- E [21/Dec/2006:18:59:36 +0100] Unable to open listen socket for address ::1:631 - Address family not supported by protocol. ---------------------------------------------------------------------------- This indicates that your system has IPv6 support but IPv6 has not been enabled for any interfaces. On my default installation of openSUSE 10.2 there are no such problems. Check your network setup. You can ignore this error message when you use only the traditional IPv4 addresses. ---------------------------------------------------------------------------- E [21/Dec/2006:19:00:13 +0100] [Job 36] Unable to open parallel port device file "/dev/lp0": Permission denied ---------------------------------------------------------------------------- This is the reason why nothing can be sent to your printer. This causes the subsequent error messages ---------------------------------------------------------------------------- E [21/Dec/2006:19:00:13 +0100] PID 13794 (/usr/lib/cups/backend/parallel) stopped with status 1! E [21/Dec/2006:19:00:30 +0100] PID 13793 (/usr/lib/cups/filter/foomatic-rip) stopped with status 9! ---------------------------------------------------------------------------- Check the permissions of /dev/lp0 On my default installation of openSUSE 10.2 it is: crw-rw---- 1 root lp 6, 0 ... /dev/lp0 Both are neither problems in CUPS nor in YaST. It works for me with a default installation of openSUSE 10.2 -- Configure bugmail: https://bugzilla.novell.com/userprefs.cgi?tab=email ------- You are receiving this mail because: ------- You are on the CC list for the bug, or are watching someone who is.