Mailinglist Archive: opensuse-arm (18 mails)

< Previous Next >
[opensuse-arm] rock64 not booting
I finally have had some time to try to get opensuse Tumbleweed to boot on my
2Gb rock64.

The image I used was downloaded from:
https://download.opensuse.org/repositories/devel:/ARM:/Factory:/Contrib:/
Rockchip/images/

After dd'ing the image to the emmc, I installed the Arch u-boot using this
install guide:
https://archlinuxarm.org/platforms/armv8/rockchip/rock64

Using these kernel arguments in grub2/grub.cfg . I'm able to see where the
boot process stops:
$linux ($root)//Image-4.19.5-1-default ${extra_cmdline} loglevel=7
earlycon=uart8250,mmio32,0xff130000 console=ttyS0,1500000n8 splash=silent
plymouth.enable=0 root=UUID=d90c3637-cea7-412c-8aa7-e3a5a47dad39 rw

So after unpacking the initramfs, it stops after saying it can't open the rtc.

[ 29.068003] Freeing initrd memory: 30036K


[ 29.071144] hw perfevents: enabled with armv8_cortex_a53 PMU driver, 7
counters available

[ 29.072396] kvm [1]: 8-bit VMID


[ 29.074816] kvm [1]: vgic interrupt IRQ1


[ 29.075557] kvm [1]: Hyp mode initialized successfully


[ 29.081276] Initialise system trusted keyrings


[ 29.082177] workingset: timestamp_bits=44 max_order=19 bucket_order=0


[ 29.083355] zbud: loaded


[ 29.086027] pstore: using deflate compression


[ 29.101879] Key type asymmetric registered


[ 29.102309] Asymmetric key parser 'x509' registered


[ 29.102901] Block layer SCSI generic (bsg) driver version 0.4 loaded (major
244)

[ 29.103982] io scheduler noop registered


[ 29.104388] io sched[ 29.104995] io scheduler cfq registered (default)


[ 29.105[ 29.105954] io scheduler bfq registered
[ 29.115404] shpchp: Standard Hot Plug PCI Controller Driver version: 0.4
[ 29.136242] Serial: 8250/16550 driver, 32 ports, IRQ sharing enabled
[ 29.163163] Serial: AMBA driver
[ 29.164563] msm_serial: driver initialized
[ 29.167928] cacheinfo: Unable to detect cache hierarchy for CPU 0
[ 29.170729] libphy: Fixed MDIO Bus: probed
[ 29.172295] mousedev: PS/2 mouse device common for all mice
[ 29.181473] ledtrig-cpu: registered to indicate activity on CPUs
[ 29.182859] EFI Variables Facility v0.08 2004-May-17
[ 29.183463] efivars: get_next_variable: status=8000000000000007
[ 29.184227] hidraw: raw HID events driver (C) Jiri Kosina
[ 29.189808] NET: Registered protocol family 10
[ 29.227610] Segment Routing with IPv6
[ 29.230255] registered taskstats version 1
[ 29.230691] Loading compiled-in X.509 certificates
[ 29.231347] zswap: loaded using pool lzo/zbud
[ 29.261624] cryptd: max_cpu_qlen set to 1000
[ 29.290314] Key type big_key registered
[ 29.318665] Key type encrypted registered
[ 29.319101] AppArmor: AppArmor sha1 policy hashing enabled
[ 29.319728] ima:p found, activating TPM-bypass!
[ 29.320325] ima: Allocated h[ 29.320986] evm: Initialising EVM extended
attributes:
[ 229.321845] evm: security.apparmor
[ 29.322192] evm: security.61] evm: HMAC attrs: 0x1
[ 29.370627] hctosys: unable to open rtc device (rtc0)

checking for rtc in the device tree blob show no entry:
fdtdump rk3328-rock64.dtb |grep rtc

Checking the kernel config does show 2 entries:
cat config-4.19.5-1-default |grep rtc
CONFIG_RTC_HCTOSYS_DEVICE="rtc0"
CONFIG_RTC_SYSTOHC_DEVICE="rtc0"

Where do I go from here?

Thanks.

Mark


--
To unsubscribe, e-mail: opensuse-arm+unsubscribe@xxxxxxxxxxxx
To contact the owner, e-mail: opensuse-arm+owner@xxxxxxxxxxxx

< Previous Next >
This Thread
  • No further messages