Hi, I'm trying to boot my udoo board (uses the imx6 quad SoC). So far, u-boot starts but when the kernel starts nothing happends. This is the u-boot log: U-Boot SPL 2015.10 (Oct 31 2015 - 09:05:51) U-Boot 2015.10 (Oct 31 2015 - 09:05:51 +0000) CPU: Freescale i.MX6Q rev1.2 at 792 MHz Reset cause: POR Board: Udoo Quad DRAM: 1 GiB MMC: FSL_SDHC: 0 *** Warning - bad CRC, using default environment In: serial Out: serial Err: serial Net: using phy at 6 FEC [PRIME] Hit any key to stop autoboot: 0 switch to partitions #0, OK mmc0 is current device reading boot.scr 2735 bytes read in 16 ms (166 KiB/s) Running bootscript from mmc ... ## Executing script at 12000000 switch to partitions #0, OK mmc0 is current device reading boot/linux.vmx 7157072 bytes read in 496 ms (13.8 MiB/s) reading boot/initrd.uboot 48673918 bytes read in 3213 ms (14.4 MiB/s) reading dtb/imx6q-udoo.dtb 32562 bytes read in 38 ms (835.9 KiB/s) Kernel image @ 0x12000000 [ 0x000000 - 0x6d3550 ] ## Loading init Ramdisk from Legacy Image at 16000000 ... Image Name: Initrd Image Type: ARM Linux RAMDisk Image (uncompressed) Data Size: 48673854 Bytes = 46.4 MiB Load Address: 00000000 Entry Point: 00000000 Verifying Checksum ... OK ## Flattened Device Tree blob at 15f00000 Booting using the fdt blob at 0x15f00000 Loading Device Tree to 4fd7d000, end 4fd87f31 ... OK Starting kernel ... I suppose there's a problem with the machine ID or seomthing similar. To debug that I see that I need to activate the DEBUG_LL option in kernel. How can I do that? Thanks! -- To unsubscribe, e-mail: opensuse-arm+unsubscribe@opensuse.org To contact the owner, e-mail: opensuse-arm+owner@opensuse.org