Op zondag 6 september 2015 19:02:53 schreef Olav Reinert:
On Sunday 06 September 2015 14.54:26 Freek de Kruijf wrote:
Op zondag 6 september 2015 12:58:55 schreef Olav Reinert:
I tried to upgrade to the new layout by installing a fresh 13.2 image:
<http://download.opensuse.org/repositories/devel:/ARM:/13.2:/Contrib:/Ra sp be rryPi/images/openSUSE-13.2-ARM-JeOS-raspberrypi.armv6l-1.12.1-Build36.9. r aw. xz>
Unfortunately, that image won't boot properly. It gets as far as the "Starting kernel ...", then it seems to hang.
You probably should use the Tumbleweed image on: http://download.opensuse.org/repositories/devel:/ARM:/Factory:/Contrib:/Ra sp berryPi:/upstream/images/
Tried it - it fails quite early in the boot process with out of memory. :-(
Tried it also, the upstream image, Build338.1. I followed the progress on my HDMI display and it finishes properly. The problem is however that it does not start the network on eth0. Inspection of the journal shows that it does not load the driver for the Ethernet interface, smsc95xx in previous images. This driver is present on the SD card. Apparently the udev system does not have a proper rule for this USB device.
I'm not soo concerned that the Tumbleweed images are finicky. But it bothers me that the 13.2 image doesn't work - that one is even mentioned in the wiki.
Unfortunately the wiki does not mention the Build version which was used when the page was written. I still have Build36.3 which I believe works. -- fr.gr. member openSUSE Freek de Kruijf -- To unsubscribe, e-mail: opensuse-arm+unsubscribe@opensuse.org To contact the owner, e-mail: opensuse-arm+owner@opensuse.org