26.03.2015 00:30, Robin Holt пишет:
Has anybody booted the JeOS...33.3 image on either a BBB or BBW?
When I attempt to boot the opensuse 13.2 JeOS...33.3 image on a BeagleBone White, the kernel gets through boot, but then fails to exec init, et. al. After some tweaking of kernel command line parameters, I managed to get the the shell in the initrd. Nearly none of the commands worked as many of the libraries reported they were not compatible with the processor.
This is for a work project where we pulled the A6 rev board off a shelf. Since I ran into the troubles, and due to the plan for this project to be BeagleBone Black based, I have ordered a BBB which should arrive today or tomorrow.
Thank you, Robin Holt
I've just checked 33.4 image with my BeagleBone BLACK, and found it working. As far as I remember BeagleBone White has 256MB RAM. Am I correct? If so, you probably run into lack of memory. 13.2 JeOSes can not boot on 256MB RAM boards. Firstboot initrd requires way more RAM. I faced the same issue when tried to run openSUSE on Phytec Wega board. However, initial initrd size has been reduced much but not enough in 13.3 (Factory) and also early swap activation has been introduced in kiwi init routines. What I can advice to you is to try openSUSE Factory image with the following trick: interrupt u-boot, and type the following commands: setenv append "rootfstype=ramfs" boot One the second boot you won't need this command. -- To unsubscribe, e-mail: opensuse-arm+unsubscribe@opensuse.org To contact the owner, e-mail: opensuse-arm+owner@opensuse.org