Hello all. I had to pull a failed drive in an array. Unfortunately there is no software to check that while the machine is up (LSI MegaRAID 320-4x). I had to restart the machine to confirm what I suspected. After changing out the drive I attempted to restart the machine. Rather than booting normally, it comes up toe the SUSE kernel selection menu, unzips the kernel, outputs "BIOS check Successful" and locks-up hard. So I tried booting with iommu=force. Then I hooked up a console so I could see what was happening and used "text console=ttyS0,115200 console=tty0" and still no output. Nothing, nada. I am about to try apic=off. This is a Tyan 2880 with 4GB of RAM (I pulled the other 2GB after it wasn't booting as it has had issues with this in the past). Ideas? -- Santiago Flores Sr. Systems Administrator Iqdirection.com santiago@iqdirection.com 480-560-3151