Hello, Am Donnerstag, 7. Januar 2016 schrieb Erico Mendonca:
I installed and tested y2r on Ruby 1.8, 2.1 and 2.3 on SLES 11 SP4 using the packages from devel:languages:ruby. They all fail with the same syntax errors on y2r code. I’m afraid I’m too much of a newbie on Ruby to take it on. Could someone help here?
I'm not an YCP, ruby or YaST expert, but - IIRC openSUSE 13.1 was the first with ruby-based YaST. Therefore I'd recommend to setup a VM with openSUSE 12.3, which most probably has the package versions that were used back then. (Maybe newer-than-12.3 Factory was used, but 12.3 should be close enough.) I'd also guess that this will work out much faster than hunting down one error after the other ;-) (It might also be a good idea to keep that VM in case someone needs it again ;-) Regards, Christian Boltz -- Die drei Todfeinde des Programmieres: Sonnenlicht, frische Luft und das unerträgliche Gebrüll der Vögel. -- To unsubscribe, e-mail: yast-devel+unsubscribe@opensuse.org To contact the owner, e-mail: yast-devel+owner@opensuse.org