-----BEGIN PGP SIGNED MESSAGE----- Hash: SHA1 Michael G. Henders wrote: | I can't comment about the fglrx thing, because I don't use it (or at | least I don't think I do). But I *am* running a Radeon 9000, and | getting 2451 FPS out of "gears". This is under SuSE (Pro) 8.2 on a P4 | at 3.06 GHz, just for reference. My recollection is a bit fuzzy, but I | do remember having some trouble with my initial setup, and I remember | trying the ATI drivers, without any success. My current setup uses just | the XFree86 "radeon" driver; YaST thinks I've got an rv250lf, just like | your system. I can't remember if that was auto-detected or not, sorry. | Regardless, I'm pretty sure that I had to get the 3D thing done in two | steps -- first, get the card properly identified, then reboot, re-enter | YaST, and select the checkbox to enable 3D support. XF86Config file | attached, for reference -- hope this helps! | | Mike Henders Well I got the mouse/touchpad working. I think the problem now is that Itried to install the ati drivers, and I havem't figured out how to completly remove them from the system. When I run rpm -e, XF86 is still looking for the XF86Config-4 and not the config w/o the -4. So no matter what I enter in sax/yast doesn't get seen. Thanks -----BEGIN PGP SIGNATURE----- Version: GnuPG v1.2.2 (GNU/Linux) iD8DBQFAqF60lC+PSm9+eB0RAtFbAJ977JFB1q7ipsy28NT1V0i8yGmZggCdFYzk +aPqr7/8/1k+OZAPTNVwZuE= =76dz -----END PGP SIGNATURE-----