Hi, folks, Hi, Juergen, I have installed FreeCAD 0.13 (from repository home:jnweiger:freecad) on OpenSuSE 12.3/x64. Installation went smooth, all dependencies were resolved. However, launch of FreeCAD 0.13 is only partial success, shell is loaded, it immediately gives error message "No module named StartGUI". Workbench -> New -> … always throws the same type of error, for example Workbench -> New -> Arch - "No module named Drawing". Anyone have any clue what might be wrong ? PyQt module is installed. Thanks in advance. Andrei -- To unsubscribe, e-mail: opensuse+unsubscribe@opensuse.org To contact the owner, e-mail: opensuse+owner@opensuse.org