Hi I am able to see driver loaded using dmesg command below is output of dmesg but i am unable to see devices attached to SAN box--Please help me to detect Tape attached to SAN switch =============================== qla2xxx_conf: no version for "struct_module" found: kernel tainted. qla2xxx_conf: unsupported module, tainting kernel. qla2xxx: unsupported module, tainting kernel. QLogic Fibre Channel HBA Driver qla2300: unsupported module, tainting kernel. qla2300 0000:28:01.0: Found an ISP2312, irq 36, iobase 0xffffff000099f000 qla2300 0000:28:01.0: Configuring PCI space... qla2300 0000:28:01.0: Configure NVRAM parameters... qla2300 0000:28:01.0: Verifying loaded RISC code... qla2300 0000:28:01.0: Waiting for LIP to complete... qla2300 0000:28:01.0: Cable is unplugged... scsi1 : qla2xxx qla2300 0000:28:01.0: QLogic Fibre Channel HBA Driver: 8.00.02 QLogic QLA2342 - ISP2312: PCI-X (133 MHz) @ 0000:28:01.0 hdma+, host#=1, fw=3.03.11 IPX qla2300 0000:28:01.1: Found an ISP2312, irq 37, iobase 0xffffff00009a1000 qla2300 0000:28:01.1: Configuring PCI space... qla2300 0000:28:01.1: Configure NVRAM parameters... qla2300 0000:28:01.1: Verifying loaded RISC code... qla2300 0000:28:01.1: Waiting for LIP to complete... qla2300 0000:28:01.1: LOOP UP detected (2 Gbps). qla2300 0000:28:01.1: Topology - (F_Port), Host Loop address 0xffff scsi2 : qla2xxx qla2300 0000:28:01.1: QLogic Fibre Channel HBA Driver: 8.00.02 QLogic QLA2342 - ISP2312: PCI-X (133 MHz) @ 0000:28:01.1 hdma+, host#=2, fw=3.03.11 IPX Vendor: M4 DATA Model: MagFile Rev: 6.0 ================================ __________________________________________________ Do You Yahoo!? Tired of spam? Yahoo! Mail has the best spam protection around http://mail.yahoo.com